cribbj wrote:
I'll ask an even dumber question; where do you get access to this console? And I assume this is for programming the low level firmware that will tell the AEM's processor that it's going to be running a 12 cylinder, spark ignited reciprocating engine, and not a gas turbine, or some other piece of industrial machinery?
Then, how do you get the tuning options in there, like VE tables for fuel, ignition advance maps, etc.?
i just sent you an 11M zip....lets see if it arrives. The very low level stuff you don't need to worry about and don't see. What you see is the logic like:
Analog_In_1->smoothing->calibration>MAP_signal
MAP_Signal->VE_table->VE_Value
VE_Value x lambda ->Required_Fuel
Like that, but with some format requirements.
Adding tables is easy
Add channel - 2D lookup, call it VE, and select RPM and load for the axis
Then to display the new table in the tuner
Add control 2D Table
Add control 3D Graph
This gives you a VE table of any size you want that you can see/tune
You can add tables, graphs, text boxes, etc for anything you please. Very simple and pretty nice.