| gemellocattivo.com http://gemellocattivo.com/forum/ |
|
| Water pump with a press fit/bonded outflow fitting. http://gemellocattivo.com/forum/viewtopic.php?f=2&t=384 |
Page 1 of 1 |
| Author: | steved033 [ Mon Sep 16, 2024 3:13 pm ] |
| Post subject: | Water pump with a press fit/bonded outflow fitting. |
Asking as a double check/opinions: I'm working on a side project for some folks where I'm drawing a water pump and it's parts in CAD. The outflow housing has 6 exit fittings (just normal hose clamp/silicone tube) but the fittings are obviously not part of the casting. They're likely press fit in, maybe even heated/interference type. A redesigned version would likely be the same, and with modern glues/sealants would for sure never come apart again. Recommendation for the sealant? sjd |
|
| Author: | mk e [ Mon Sep 16, 2024 8:16 pm ] |
| Post subject: | Re: Water pump with a press fit/bonded outflow fitting. |
sorry, over my head as I didn't realize glued joints in metal parts were even a thing. For those that its not they will likely need to know the materials. |
|
| Author: | steved033 [ Mon Sep 23, 2024 7:02 am ] | ||
| Post subject: | Re: Water pump with a press fit/bonded outflow fitting. | ||
It's actually a non-issue now as the project was to "modernize" so new seals, real bearings, it's a zero pressure system. I found a -12 ORB to 1" hose fitting that will work perfect for what I needed.
|
|||
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|