Back to work this weekend.... trying to leave the TV off so out in the shop to have a look at motor mount. First up rebore them from 3.125 to 3.625 so the TR mount fit in.
Attachment:
20220305_101834-resized-1024.jpg [ 322.99 KiB | Viewed 4693 times ]
Attachment:
20220305_103626-resized-1024.jpg [ 294.83 KiB | Viewed 4693 times ]
Once that was done I did a quick check on the engine
Attachment:
20220305_162857-resized-1024.jpg [ 273.62 KiB | Viewed 4693 times ]
Attachment:
20220305_162900-resized-1024.jpg [ 272.03 KiB | Viewed 4693 times ]
Looks good.....wait a minute....its upside down, DOH!
after pondering a bit I decided I can swap the brackets front to back and flip them upside down and get a reasonably good outcome. but the puts the mount on the top so I figured I should have all 4 bolts, which meant cutting ans welding a bit to move a support
Attachment:
20220305_171906-resized-1024.jpg [ 245.43 KiB | Viewed 4693 times ]
But now it looks pretty good, I just need to make a spacer to go under as it should be touching the blocks siting under it.
Attachment:
20220305_175121-resized-1024.jpg [ 270.54 KiB | Viewed 4693 times ]